Sony PSP Mod & PSP Hacks Forums - View Single Post

PvP_LostKnight · 08-23-2008, 06:08 AM

I'm getting a rapid prototyper soon. A rapid prototyper is basically a 3d printer that prints out any 3d object that I want out of plastic from 3d software on my computer. I'm thinking of redesigning the PSP shell to accompany for certain mods. Was wondering if anyone was interested in buying these shells. More than likely you can't put the UMD drive back in but if you use CFW you shouldn't care that much

Certain mods that I had in mind was:
* second joystick area below the right face buttons.
* 24 hour battery
* FPS V3.0 (might be costly)

Cost will range from 60-100 USD. Was wondering if I had it in stock would anyone buy it from me?

08-23-2008, 06:08 AM	#1 (permalink)
PvP_LostKnight Senior Member PSP Mad Hacker Join Date: May 2008 Posts: 628 Firmware Installed: 3.40 OEA	Concept PSP Shells I'm getting a rapid prototyper soon. A rapid prototyper is basically a 3d printer that prints out any 3d object that I want out of plastic from 3d software on my computer. I'm thinking of redesigning the PSP shell to accompany for certain mods. Was wondering if anyone was interested in buying these shells. More than likely you can't put the UMD drive back in but if you use CFW you shouldn't care that much Certain mods that I had in mind was: * second joystick area below the right face buttons. * 24 hour battery * FPS V3.0 (might be costly) Cost will range from 60-100 USD. Was wondering if I had it in stock would anyone buy it from me? __________________ I look down on people who do LED mods. I love hot glue, if you don't then f*** you.