[aaa801]

i acidently snapped the cable of the board for the wifi antenna where the cable connects to the antenna
ive been trying to find a site that sells the antenna
can anyone help
please note that i cant use paypal attall as my card is crappy
i can however use visa payment if its a direct thing

[aaa801]

o its a 1k btw

[Gameunreal]

You can look for a replacement wifi on ebay or a psp fix site. Or you can get a new PSP

[slowman]

The antenna wire snapped? Just solder it back and put a perfect square of electrical tape above and below it to seal it and prevent it from shorting something.

[Gameunreal]

That should be quite hard, unless he was very lucky and got a perfectly clean break line

[linkin2b]

im having issues soldering mine back on as well. are the solder points supposed to bridge the two contacts or are they supposed to be seperate?

[Gameunreal]

Soldering back a antenna wire will be VERY hard. You should use it like plaster: to hold the JOINED ends together.

[aaa801]

Hea i soldered it back on with a 800wat iron xD
guys what you have to do is remove the power board and melt some solder ontf the 2 pads om the antenna then the cable has 2 WIRES INSIDE IM use a pair of plyers to pinch a thin bit off the end then wrap up the guard wire (like tv cable) and then strip the plastic of the middle pin (BE CAREFULL) it cuts easy lol, solder the center pin to the right hand side pad and the guard to the left hand side pad THE TWO WIRES MUST NOT TOUCH, put back in the power pcb, note it may not go into place fully but when the psp is back in one peice it should be clamped down, then go wifi!

[Gameunreal]

That post should have big HARDCORE labels stamped all over

[aaa801]

Mhm good hardcore lol, o.o found the first release of pspr on my psp lol must beat game