GUIDE TO::Making Pandora's Battery (*new method*) - Page 4

jerry197666 · 10-24-2007, 05:58 AM

i joined this site not too long ago as u guys can see i dont have many posts, but i come here everyday to read the walkthrus and FAQ and they sure paid off, following this one step my step and doin some research on this site i finally upgraded my PSP Slim 3.60 to 3.71M33.

Great site guys and thanx for all the hard work

Caliga · 10-24-2007, 07:58 PM

finally got it to work. and if anyone did not say it yet, the installer will not work right in vista, thank god i have swapable hard drives with vista/xp/2000/98...

Powerpunk 5000 · 10-26-2007, 05:52 AM

Quote:

(to do this, start the psp with both the ceated memory card and the softmodded battery. You may or may not see anything. But the MS LED and the wifi LED should glow for a second. If it does, just press X and let that run for about 5 minutes. if it doesnt, try re-creating the memory stick)

This happened to me. It turned on, but no flashing. So... try re-creating the memory stick? HOW? I can't do it on the PSP anymore, obviously...

robakri · 10-26-2007, 04:27 PM

okay I just got my slim and I am a total noob to this. However I have been reading alot lately and I think I have this covered, there are only a couple of things I don't quite get.

Well i'm not going to make my own battery, I just ordered one from codejunkies.

Now can I use my psp slim to copy the files from the noob installation to the memory stick?

And when I am finished and put in the normal battery, does the LCD then work? How do I run the unbricker if it doesn't work?, Hell, how do I run it if the LCD works, I have no idea.

jerry197666 · 10-26-2007, 11:38 PM

when i did it on my SLim i had to do a BLIND install, the MS LED and the wifi LED were glowong and blinking, i just pressed X and let it run for about 3 minutes then took the Pandora battery out and put my charger on it and it worked

dbomb90 · 10-27-2007, 01:12 AM

this is a easy to follo guide i recommend this to noobs or any one with 2 batteries and or have no CFW or homebrew elgibility

firzzle1991 · 10-27-2007, 04:48 PM

I have a 2.0 gig sandisc pro Duo but its not specifically for games. Can I make a magic memory stick with one?

moneymovitch · 10-27-2007, 07:01 PM

is there anyway to charge it after you cut the pin cause i forgot to charge it and now its dead, i put it in and it ownt charge. or could this be the problem:

its kinda hard to see, buts theres a small hole in the silver stuff, when i was cutting it it must have poke through, a small amount of smoke came out.

Anyways, is there any way i could fix this?

zygried14 · 10-27-2007, 11:05 PM

hahaha its working..thks for this guide

DeeKay · 10-28-2007, 06:23 PM

OK so I opened the battery, and lifted the pin. I tested the battery and when i insert it the Power LED comes on, but the screen remains blank. It's a slim PSP so I get the blank screen. But the problem I'm having is that the MS LED and the WiFi LED weren't lit at all. Does anyone have any ideas?

Does anyone know where I can get a battery that is compatible with the softmod? I think the battery I used may have been too new.

TweaKs · 10-28-2007, 08:09 PM

Where is the kd and registry files?

You said you'd put them at the bottom but nothings there.

Big-V316 · 10-29-2007, 12:55 AM

Hi guys

I am new to the board and this is my first post. I tried the new method for creating a pandora's battery and so far this is what is happening. The battery goes in and the green light comes on and does not go off. I can't use my PSP to format the memory stick because it locks up when you get past the first screen. I am finding that things are getting worse because before I could cold boot and every third time or so the wifi light would come on and it would boot then hang up. Now I can't seem to get it to boot at all. I can't tell if it's the memory stick since I ended up using my laptop to format it then I copy the files over. Any help would be great.

Caliga · 10-29-2007, 03:25 AM

Quote:

Originally Posted by TweaKs

Where is the kd and registry files?

You said you'd put them at the bottom but nothings there.

step 10 and 11( i think thats the ones) should not be in there to be honest, it confused me for a while but if you follow the other steps it will actually make them for you.

Midian · 10-29-2007, 04:05 AM

lol sorry for my absence from this post, i didnt realize it was getting so many posts!

well, im sure everyone has their questions answered and im glad everyone is happy for the tutorial.

(this should be stickied btw lol)

overkilller · 10-29-2007, 11:52 PM

its all gone well so far! but when i try to run Pandora Battery Creator I get this error

"The game could not be started.
(8002014C)"

any ideas?
I also get similar erorr when trying to run an 3.52 M33 Update