How to: Pandora's Battery - High Res Pics - Page 6

reiko157 · 12-07-2008, 07:00 AM

Quote:

Originally Posted by [FS]A

I was scoring the battery to open with the blade and there were sparks n sum white smoke. its not open yet, tried the battery and its still werking. could i mess this up, whats going on?
* ok, its a day later and after reading the posts about explosive batterys im a bit worried. I opned the battery finaly and noticed a fine slit on the cell, not sure if its gone threw but its a visible line along it from when i was cutting the plastic. Ive charged it, and discharged it fully. Theres a minenoot smell but only when **i put my nose to the battery**. SHould i be throwin this battery away? I dont really wanna, money is tight!

rofl, toxic fumes

voltaire1923 · 01-30-2009, 02:59 AM

note the aviod dead shorting I did that when my blad sliped trying to get that pin off. it killed my battery

bamaPSPboy · 02-03-2009, 12:14 AM

thanks this helped a lot. Good Hi-res Pic to boot.

Old_snake · 02-19-2009, 10:35 PM

I was trying to remove the pin, and i poked it, and when i went under the pin to pull it, it all of a sudden release a puff of smoke, and i dropped it on the table. So what does that mean if it smoked? Did i short circuit something? I also tapped it up and tried turning on my psp with it and it still worked.

Never mindzors, i finally disconnected the pin by using toenail clippers, and grounding myself before even touching anywhere near the board, just to be sure not to short circuit.

dabriguy · 03-08-2009, 06:52 AM

i dont understand this but how come my battery looks like the one in the picture "on the ouside"but on the inside its totally different? the chip is at the top not all on it like that

loki777 · 04-09-2009, 04:52 PM

Thanks this helped me so much!

xxtom16 · 04-12-2009, 11:10 PM

Thanks, this is the most useful guide ive seen yet. ++ Ifyou have real steady hands, and dont have access to a desolderer, use a fine needle for sowing, poke into the arch of the pin, and use the "TE05" chip as a fulcrum, digging under the solder. If you do it right, youll pop the pin up off the green circuit board.

xxtom16 · 04-12-2009, 11:11 PM

Quote:

Originally Posted by dabriguy

i dont understand this but how come my battery looks like the one in the picture "on the ouside"but on the inside its totally different? the chip is at the top not all on it like that

check if you have the 2200 mA/h battery, if so, itll be on top.

karateking56 · 07-08-2009, 02:09 AM

these r picks of my battery could someone teach me how to make a pandora battery with this battery
http://s690.photobucket.com/albums/v...7092101-00.jpg
http://s690.photobucket.com/albums/v...7092102-00.jpg
http://s690.photobucket.com/albums/v...7092102-01.jpg
http://s690.photobucket.com/albums/v...7092106-00.jpg

karateking56 · 07-08-2009, 02:31 AM

also i already have a mms and the batery ishowed u is made in china and came with my psp 1001 and is a model 110

Meatgull · 07-13-2009, 12:43 AM

sorry dude but last I checked no ones knows how to mod that battery. I have been over the net looking how to. Someone might have found a way by now idk. If yah find some one message me I would love to know how to. I just know that you have to pull a pin on one of the chips but on this battery idk wat chip or pin that is.

clonecrazy435 · 08-19-2009, 11:27 PM

So, I just cut the pin in half right?

MagnusPrime · 08-21-2009, 05:26 AM

i have the sam batt as javed syed66-nice pics btw. if you have ne luck pm me plz

devilboymahin · 10-07-2009, 03:04 PM

gosh this is hard ! can i just buy the pandora battery ?